1.make sure your bettery has enogh voltage for the controller to recognize the bettery type before first installation.
2.The bettery cable should be as short as possible to minimize loss.
3.The regulator is only suitable for lead acid batteries:OPEN,AGM,GEL it is not suited for nickel metal hydride, litheium ions or other batteries.
4.The charge regulator is only suitable for regulating solar modules. Never connect another charging source to the charge regulator.
1.Build-in industrial micro controller.
2.One-key setting, digital display.
3.Fully 4-stage PWM charge management.
4.Built-in short-circuit protection, open-circuit protection, reverse protection, over-load protection.
5.Reverse current protection, low heat production.
1.Connect the battery to the charge regulator-plus and minus. it will show<1>if it detects 12V battery,<2>if it detects 24V battery.
2.Connect the photovoltaic module to the regulator-plus and minus.
The recerse order applies when deinstalling!
An Improper sequence order can damage the controller!
Press the setting button to activate the mode display, press the button for 3 seconds, and select the desired mode.
Display Mode Description
0 Charge only Only use the charge function of the controller. Load output is forever closed
1-13 Light-open+delay Load on after sunset and closed after 1-13hours
L D2D Dusk to Dawn(have delay)
C System Load always output(unless battery is low)
H Hand Open the load manually
d Debug Dusk to Dawn(no delay)
Note:When the screen flashes on the <FU>, the description has been in the heat, over current, or lost. Out of short circuit protection, this time should be reduced load or eliminate the short circuit, after entering the protection, the exceptiopn solution in addition to the system will delay a period of time to open the ouput.
1 x Solar Charge Controller 12V 24V 10A